https://www.doitbest.com/products/royalty-ii-china-lavatoryIf you are fond of antiques and consider yourself handy, you can repurpose an antique cabinet to use in the bathroom. Simple retrofitting makes an antique cabinet an attractive vanity. This project takes about one day to complete and costs between $100 and $250, creating a unique and very attractive addition to your home.
You will need:
Step 1: Buy a porcelain sink and create a template of it using the paper and pencil.
Step 2: Take the sink template when looking for an antique cabinet with a sturdy top and a height of between 34 and 36 inches. If you choose a cabinet with doors, not drawers, you will not need to perform any retrofitting on the interior.
Step 3: Place the sink template on the top of the cabinet and use the pencil to trace the area on the surface. This indicates where the sink and faucets will be located.
Step 4: Cut the hole for the sink in the cabinet top, using the orbital saw. Place the sink in this hole. Double-check the outlined locations for water faucets and handles to ensure they are correct.
Step 5: Trace the cartridges of the handles and faucets on the top of the cabinet with the pencil. Use a corresponding size drill bit and the drill to cut the holes for the cold and hot water faucets and handles.
Step 6: Push the faucet cartridges through the holes, working from underneath the cabinet. Attach the handles for the cold and hot water.
Step 7: Apply the plumber’s putty to the faucet base resting on the vanity. Tightly press the faucet base into the vanity. Secure the faucet to the top of it.
Step 8: Place the cabinet flush against the wall and identify where the plumbing comes through from this wall. Use the orbital saw to cut the rear of the cabinet in the appropriate locations. Make sure your holes are large enough to offer convenient access to plumbing.
Step 9: Slide the cabinet against the wall. Go underneath the sink and screw a p-trap on the drain. You may be able to do this by hand but a wrench will help prevent leaking.
Step 10: Attach the cold and hot water supply lines, tightening the fittings with your hand to prevent stripping. Connect these lines to the water shutoff valves on the main piping for the water supply.